HOW TO

Knot THE STRAPは手で簡単に着け替えができるウォッチストラップです。

How to use Knot THE STRAP

put on a buckle

  1. 1. Insert the spring bar into the hole in the buckle

    The bars that stick out on both sides of the belt are called "spring bars."
    First, insert the spring bar on the opposite side of the lever into the buckle's mounting hole.
    *Attach the buckle to the side with the belt loop (fixed leather) and the other side to the watch body.

  2. 2. Slide the lever and insert the other side as well.

    Move the belt while sliding the lever, and insert the spring bar on the other side into the hole in the buckle. Pull the buckle a little to make sure it is firmly attached to the belt and you are done.

Click here for D buckle

attach the strap

  1. 1. Insert the spring bar into the hole of the clock

    Turn the watch and belt over. First, insert the spring bar on the opposite side of the lever into the hole in the watch body.

  2. 2. Slide the lever and insert the other side as well.

    Move the belt while sliding the lever, and insert the spring bar on the other side into the hole in the watch body. Pull the belt a little to make sure it is firmly attached to the watch body and you are done.

Click here for Apple Watch

D buckle

  1. 1. Insert the spring bar into the hole of the D buckle

    First, attach the D buckle to the fixed loop (fixed leather) side of the belt. Check the installation direction by looking at the top and bottom of the logo, then turn it over once.
    Insert the spring bar on the opposite side of the belt lever into the hole in the D buckle.

  2. 2. Slide the lever and insert the other side as well.

    Move the belt while sliding the lever, and insert the spring bar on the other side into the hole in the D buckle. Pull the D buckle slightly to make sure it is securely attached to the belt.

  1. 3. Attach the strap to the watch body

    “Knot THE Attach the strap to the watch body in the same way as in "How to use STRAP/Attach the belt."

  2. 4. Pass the tip of the belt through the buckle

    Open the back side of the part with the D buckle logo and pass the tip of the belt through. Close the buckle so that the protrusion on the open part (inside) goes into the hole in the belt. Check the size by wearing it on your wrist and adjust the hole position accordingly.

How to use stainless steel belt

  1. 1. Hook the hook on the inside of (A) onto the rod of the fastener on the opposite side.

    *If you do not hook it properly, it may fall or be damaged. /p>

  2. 2.Put (B) over the hook and push it in.

    Make sure it is firmly fixed.

  1. 3. Then, cover (B) with (C) and press it in.

Stainless steel belt size adjustment

  1. 1. Insert a small flat head screwdriver (or similar tool) into the hole in the fastener as shown and lift up the fastener

  2. 2. Slide the clasp, align the groove on the back of the belt with the groove on the clasp at a position that matches your arm size, and press it with your fingers to prevent it from moving.

  1. Insert the tool into the hole of the fastener as in 3.1 and push it back using the lever principle.

    *There is a risk of damage if the grooves are not fitted or if you forcefully move it using another method.