For Apple Watch

By using a special adapter, it can also be used with Apple Watch.
You can use Knot THE STRAP.
*Please order the dedicated adapter as an option when ordering the strap.

• List of compatible models

buckle the strap

1. 

   1. Hook the spring bar into the hole of the buckle

   The bars that stick out on both sides of the belt are called "spring bars." First, insert the spring bar on the opposite side of the lever into the buckle's mounting hole.
   *Attach the buckle to the side with the belt loop (fixed leather) and the other side to the watch body.

2. 

   2. Slide the lever and insert the other side as well.

   Move the belt while sliding the lever, and insert the spring bar on the other side into the hole in the buckle. Pull the buckle a little to make sure it is firmly attached to the belt and you are done.

remove existing band

1. 

   1. Band removal button

   When you flip the Apple Watch over, there is a band removal button.

2. 

   2. Slide while holding down the button

   Slide the band while pressing the button.
   *Please work on a soft cloth to avoid scratching the watch.

Attach the Knot THE STRAP

1. 1.Attach the special adapter

   Attach the adapter compatible with your Apple Watch to the Apple Watch itself. Make sure that the stainless steel center side of the adapter faces the back of the watch.

2. 2.Attach the Knot THE STRAP

   Attach the belt in the same way as " How to install Knot THE STRAP ". Check that the belt is firmly attached by pulling on it slightly. Also check if the adapter does not slide.

Size comparison (wearing image)

• AppleWatch size 40mm
  Belt width 20mm

  

• AppleWatch size 44mm
  Belt width 22mm